LTC69 Search Results

LTC6909

Abstract: LTC6908 LTC6908-2 LTM4601 LTM4601-1 sine wave power inverter LTC6906 500KHz
Contextual Info: LTC6909 1 to 8 Output, Multiphase Silicon Oscillator with Spread Spectrum Modulation Features Description 1-, 2-, 3-, 4-, 5-, 6-, 7- or 8-Phase Outputs n One External Resistor Sets the Output Frequency from 12.5kHz to 6.67MHz n Optional Spread Spectrum Frequency for Improved

LTACS

Abstract: LTC6910-1 LTC6910-2 LTC6910-3 marking LTACS LTC6910-3CTS8 LTC6910-3ITS8
Contextual Info: Final Electrical Specifications LTC6910-3 Digitally Controlled Programmable Gain Amplifier in SOT-23 April 2003 U FEATURES • ■ ■ ■ ■ ■ ■ ■ ■ ■ DESCRIPTIO 3-Bit Digital Gain Control 0, 1, 2, 3, 4, 5, 6 and 7V/V 8-Pin TSOT-23 Package Rail-to-Rail Input Range

LT1086-5

Abstract: LTC692 LTC693 MAX690 62512 RAM LT693
Contextual Info: LTC692/LTC693 Microprocessor Supervisory Circuits FEATURES n n n n n n n n n n n n DESCRIPTION Guaranteed Reset Assertion at VCC = 1V 1.5mA Maximum Supply Current Fast 35ns Maximum Onboard Gating of RAM Chip Enable Signals 4.40V Precision Voltage Monitor

LTABN

Abstract: LTAES ltc6903hms8pbf S2126 74HC74A LTC6904 LTC6904CMS8 LTC6903 PIC16F73 PIC16F73 block diagram for digital clock
Contextual Info: LTC6903/LTC6904 1kHz – 68MHz Serial Port Programmable Oscillator Features n n n n n n n n n n n n Description 1kHz to 68MHz Square Wave Output 0.5% Typ Initial Frequency Accuracy Frequency Error <1.1% Over All Settings 10ppm/°C Typical Frequency Drift Over

Contextual Info: LTC6945 Ultralow Noise and Spurious 0.35GHz to 6GHz Integer-N Synthesizer DESCRIPTION FEATURES n n n n n n n n n n n n n n Low Noise Integer-N PLL 350MHz to 6GHz VCO Input Range –226dBc/Hz Normalized In-Band Phase Noise Floor –274dBc/Hz Normalized In-Band 1/f Noise

Contextual Info: LTC6905 17MHz to 170MHz Resistor Set SOT-23 Oscillator FEATURES n n n n n n n n n n n One External Resistor Sets the Frequency Fast Start-Up Time: 100µs Typical Frequency Range: 17MHz to 170MHz Frequency Error ±0.5% Typ 17MHz to 170MHz TA = 0°C to 70°C, Over All Settings

Contextual Info: LTC695IS Linear ICs Battery/Power Supply Monitor Circuit statusû Military/High-RelN Output Voltage Nominal V 5.0 Load Current Max. (A)1.0m Drop-Out Volt Max. P(D) Max. (W)500m Nom. Supp (V)5.0 Minimum Operating Temp (øC)-40 Maximum Operating Temp (øC)85

Contextual Info: LTC692IN8 Linear ICs Battery/Power Supply Monitor Circuit status Military/High-RelN Output Voltage Nominal V 5.0 Load Current Max. (A)1m Drop-Out Volt Max. P(D) Max. (W)500m Nom. Supp (V)5.0 Minimum Operating Temp (øC)-40 Maximum Operating Temp (øC)85 Package StyleDIP

sram 62512

Abstract: 62128 SRAM 62512 RAM 62512 sram sram 62128 LTC1235CS sram 62512 dip 62512 LT1086-5 LTC1235
Contextual Info: LTC1235 Microprocessor Supervisory Circuit U DESCRIPTIO FEATURES • ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ The LTC1235 provides complete power supply monitoring and battery control functions for microprocessor reset, battery backup, RAM write protection, power failure warning and watchdog timing. The LTC1235 has all the LTC695

LTC6946

Contextual Info: DEMO MANUAL DC1705B LTC6946 Ultralow Noise and Spurious Integer-N Frequency Synthesizer with Integrated VCO DESCRIPTION DC1705B features the LTC 6946, an ultralow noise and spurious integer-N frequency synthesizer with integrated VCO. The VCO uses no external components and is internally calibrated without external system support.

Contextual Info: rru n m TECHNOLOGY _ LTC699 Microprocessor Supervisory Circuit fcoturcs DCSCRIPTIOn • ■ ■ ■ ■ ■ ■ ■ The LTC699 provides power supply monitoring for microprocessor-based systems. The features include mi­ croprocessor reset and watchdog timing. Precise internal

Contextual Info: r r u n m TECHNOLOGY LTC694-3.3/ LTC695-3.3 3.3V M icroprocessor Supervisory Circuits FEATURES DESCRIPTlOn • UL Recognized T O n ie # E145770 ■ Guaranteed Reset Assertion at Vcc = 1V ■ Pin Compatible with LTC694/LTC695 for 3.3V Systems ■ 200|aA Typical Supply Current

LTK2

Abstract: ltk3 LTspice LTC6902CMS-PBF 2. The greatest frequency of 200KHZ do
Contextual Info: LTC6902 Multiphase Oscillator with Spread Spectrum Frequency Modulation U FEATURES • ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ 2-, 3- or 4-Phase Outputs Optional Spread Spectrum Frequency Modulation for Improved EMC Performance 5kHz to 20MHz Frequency Range

LTC6993HS6-3

Abstract: LTC6993CS6-3 ltc6994 AK024D LTC6992 LTC6993-1 LTC6994-1 solenoid driver 24v LTC6990 LTFm
Contextual Info: Electrical Specifications Subject to Change LTC6993-1/LTC6993-2 LTC6993-3/LTC6993-4 TimerBlox: Monostable Pulse Generator One Shot Features n n n n n n n n n n n n Description Pulse Width Range: 1µs to 33.6 Seconds Configured with 1 to 3 Resistors Pulse Width Max Error:

LTC6908-2

Abstract: LTC6909 LTC6906 500KHz LTC6909CMS LTC6908 LTM4601 LTM4601-1 marking mdac
Contextual Info: LTC6909 1 to 8 Output, Multiphase Silicon Oscillator with Spread Spectrum Modulation FEATURES • ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ DESCRIPTION 1-, 2-, 3-, 4-, 5-, 6-, 7- or 8-Phase Outputs One External Resistor Sets the Output Frequency from 12.5kHz to 6.67MHz

LTC6911-1

Abstract: LTC6911-2 LTC6911CMS-2
Contextual Info: LTC6911-1/LTC6911-2 Dual Matched Amplifiers with Digitally Programmable Gain in MSOP U FEATURES • ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ DESCRIPTIO The LTC 6911 is a family of low noise digitally programmable gain amplifiers PGAs that are easy to use and

LTC1789

Abstract: LTC1168 ltc1101 LTC6915 LTC6915CDE LTC6915IDE LTC1789-1
Contextual Info: LTC6915 Zero Drift, Precision Instrumentation Amplifier with Digitally Programmable Gain U FEATURES • ■ ■ ■ ■ ■ ■ ■ ■ ■ DESCRIPTIO The LTC 6915 is a precision programmable gain instrumentation amplifier. The gain can be programmed to 0, 1,

IC 566 function generator

Abstract: cr10-104jm application of IC 566 function generator LTC6910-2 max2501 OF IC 566 SE 566 IC LTC6910-1 Frequency Generator 1KHZ digital gain control
Contextual Info: QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 566 DIGITALLY CONTROLLED PROGRAMMABLE GAIN AMPLIFIER LTC6910 DESCRIPTION Demonstration circuits 566A-A, -B and -C, feature the easy to use, rail-to-rail input and output LTC6910 series of Low Noise Programmable Gain Amplifier

ltdxb

Abstract: NC7W04P6X LTC699X LTC6992-1 DC1652A-C ltc6990 LTC6992 LTC6993-4 LTC6993-1 LTC6993-2
Contextual Info: DEMO CIRCUIT 1562A LTC699X START GUIDE LTC699X-X TimerBlox: Oscillators, One Shots, PWM, and Delay DESCRIPTION Demonstration circuit 1562A is an engineering tool to design and evaluate the LTC699X-X family of TimerBlox circuits. The center section of the board

Isolation Timing Circuits

Abstract: LTC6991 capacitor-based sot23 footprint "Watchdog Timers"
Contextual Info: News Release ⎜ www.linear.com Tiny Low Frequency Clock Chip Supports Long Duration Timing from 1ms to 9.5hrs MILPITAS, CA – September 1, 2010 – Linear Technology announces the LTC6991, a simple, accurate low frequency clock specifically designed for long duration timing applications. The

LTC6930

Abstract: LTC6930-8
Contextual Info: News Release ⎜ www.linear.com Precision Micropower Oscillators Offer 99.91% Accuracy MILPITAS, CA – June 23, 2008 – Linear Technology announces the LTC6930, a family of low power precision silicon oscillators with fixed frequencies from 32.768 kHz to 8.192 MHz. Five

LTC6900

Abstract: LTC6905 DIP8 socket LTC1799 LTC6905-XXX LTC6906 LTC6908-X DC814A2C DC814D-K LTC6908x
Contextual Info: DC814 QUICK START GUIDE DEMO CIRCUIT DC814 QUICK START GUIDE SILICON OSCILLATOR DEMONSTRATION CIRCUIT: LTC1799, LTC6900, LTC6905, LTC6905-XXX, LTC6906, LTC6907, LTC6908-X DESCRIPTION Demonstration circuit DC814 provides a simple evaluation circuit for Linear Technology’s resistor-set and fixed frequency

LTC6905-100

Abstract: LTC6905I-XXX LTC6905-133 LTC6905-XXX Series LTC6905-XXX LTC6905-80 LTBP LTBPH
Contextual Info: LTC6905-XXX Series Fixed Frequency SOT-23 Oscillator U FEATURES DESCRIPTIO • The LTC 6905-XXX series are precision, fixed frequency silicon oscillators designed to minimize board space while maximizing accuracy and ease of use. ■ ■ ■ ■ ■ ■ ■

LTC6948

Abstract: 4910G
Contextual Info: LTC6948 Ultralow Noise 0.37GHz to 6.39GHz Fractional-N Synthesizer with Integrated VCO Description Features Low Noise Fractional-N PLL with Integrated VCO n No ∆-∑ Modulator Spurs n 18-Bit Fractional Denominator n –226 dBc/Hz Normalized In-Band Phase Noise Floor