OUTPUT IMPEDANCE Search Results

modbus-rtu

Abstract: I-6042M RTU DATA SHEET modbus circuit PROTOCOL fsr temperature modbus modbus protocol I-6024 modbus rtu
Contextual Info: I-6024/I-6024M 4-channel Isolated Analog Output Module Specifications Channels Effective Resolution Output type Output range Output impedance Accuracy Zero drift Span temperature coefficient Programmable output slope Isolation voltage Analog Input 4 12 bits

0-10V

Abstract: modbus-rtu DAC 0-10v modbus fsr temperature
Contextual Info: 1-channel Isolated Analog Output Module Specifications Channels Effective Resolution Output type Output range Output impedance Accuracy Zero drift Span temperature coefficient Programmable output slope Isolation voltage Analog Input 1 12 bits mA, V 0-10V, ±10V, +20mA

Contextual Info: Semiconductor Operational Amplifiers Definition of Terms Large-Signal Voltage Gain: The ratio of the output voltage swing to the change in input voltage required to drive the output from zero to this voltage. Output Impedance: The ratio of output voltage to output

sor pressure switch

Abstract: ZS-28-B SENSOR PBT gf 35 ZS-27-C ZS-27-D PSE303 ZS-28-A transform* 2 red wires PSE30 PSE301
Contextual Info: Accuracy Analog Output Current Output *3 Output Voltage:1 to 5V (within rated pressure range) Output impedance: approx.1kΩ, Linearity: ±0.2%F.S. (Without sensor) Response time: less than 150ms ±0.6%F.S. ±1.0%F.S. ±1.5%F.S. Output Current: 4 to 20mA (within rated pressure range),

connector FANUC

Abstract: FANUC ELECTRICAL MANUAL VMIVME 4140 fanuc Panduit Panduit 120-964-435 fanuc i/o VMIVME-4140 120-964-435 fanuc power
Contextual Info: VMIVME-4140 32-Channel 12-bit Analog Output Board • • • • • • • • • • • • • 32 analog output channels – 10 mA maximum output current per channel – One 12-bit D/A converter DAC per output channel 0.8 : output impedance Random update (nonscanning)

VMIVME 4140

Contextual Info: VMIVME-4140 32-Channel 12-bit Analog Output Board • 32 analog output channels — 10 mA maximum output current per channel — One 12-bit D/A converter DAC per output channel • 0.8 Ω output impedance • Random update (nonscanning) • Software or external synchronous update of double-buffered outputs

STV 2268 H

Abstract: RC7315
Contextual Info: General Product Description ♦ High output slew rate 1.8 V/ns typical ♦ Wide output voltage range (-2.5V to +7V), and up to 9.5 Vp-p swings ♦ Three-state/high impedance output ♦ High repetition rate (250 MHz for ECL swings) ♦ Low output offset (20 mV typ.) and output offset drift

Contextual Info: RC7315/T Features General Product Description ♦ High output slew rate 1.8 V/ns typical ♦ Wide output voltage range (-2.5V to +7V), and up to 9.5 Vp-p swings ♦ Three-state/high impedance output ♦ High repetition rate (250 MHz for ECL swings) ♦ Low output offset (20 mV typ.) and output offset drift

Contextual Info: Features General Product Description ♦ High output slew rate 3.2 V/ns typical driving coax ♦ Wide output voltage range (-3.0V to +7V), and up to 9.5 Vp-p swings ♦ Three-state/high impedance output ♦ High repetition rate (550 MHz for ECL swings) ♦ Low output offset (20 mV typ.) and output offset drift

DIGITAL TO ANALOG 0-10V CONVERTER

Abstract: DTL22A-LC DTL23A DTL-HS100D12
Contextual Info: Preliminary ® INNOVATION and EXCELLENCE DTL Series DTL23A Model Voltage-Controlled, 2 Amp 100 Watt, Electronic Loads Features 0-10V Input/control voltage 0-2A output/load current 2.5-200V output compliance voltage 0-100W output/load power 10MΩ output impedance

DTL24A

Abstract: DTL22A-LC DTL-HS100D12 electronic load DIGITAL TO ANALOG 0-10V CONVERTER
Contextual Info: Preliminary ® INNOVATION and EXCELLENCE DTL Series DTL24A Model Voltage-Controlled, 10 Amp 100 Watt, Electronic Loads Features 0-10V Input/control voltage 0-10A output/load current 2.5-150V output compliance voltage 0-100W output/load power 10MΩ output impedance

AC/DC Electronic Load

Abstract: dc Electronic Load Amp. mosfet 800 watt 100W 12 volt DTL22A murata relay line transistor substitution chart DTL22A-LC DTL-HS100D12 50 Watt MOSFET amplifier
Contextual Info: DTL Series www.murata-ps.com DTL22A Model Voltage-Controlled 20 Amp 100 Watt, Electronic Loads Features • 0-10V input/control voltage ■ 0-20A output/load current ■ 2.5-50V output compliance voltage ■ 0-100W output/load power ■ 10MΩ output impedance

Contextual Info: NJM2521 3-INPUT 1-OUTPUT AUDIO SWITCH GENERAL DESCRIPTION The NJM2521 is 58k input impedance 3-input 1-output audio switch. It contains two bias-type inputs and one buffer-type output. FEATURES Operating Voltage Crosstalk Input Impedance 3-Input,1-Output Bipolar Technology

Contextual Info: NJM2520 2-INPUT 1-OUTPUT AUDIO SWITCH GENERAL DESCRIPTION The NJM2520 is 58k input impedance 2-input 1-output audio switch. It contains two bias-type inputs and one buffer-type output. FEATURES Operating Voltage Crosstalk Input Impedance 2-Input,1-Output Bipolar Technology

Contextual Info: 74AHC1G125 SINGLE BUFFER GATE WITH 3-STATE OUTPUT Description Pin Assignments The 74AHC1G125 is a single non-inverting buffer/bus driver with a 3-state output. The output enters a high impedance state when a HIGH-level is applied to the output enable OE

Contextual Info: ^ e j> m aataan oaoiTa^ ^oh highest figure of merit SCC 3-vs-zb Phase Detectors T- ?J-8^ SCIENTIFIC/ MINI-CIRCUITS 1000mV DC output, + 7dBm RF ZRPD FREQUENCY MHz MODEL SCALE FACTOR IMPEDANCE ohms OUTPUT LOAD ISOLATION (dB) RF1 RF2 OUTPUT POLARITY DC OUTPUT

Contextual Info: 74AHCT1G125 SINGLE BUFFER GATE WITH 3-STATE OUTPUT Pin Assignments Description The 74AHCT1G125 is a single non-inverting buffer/bus driver with a 3-state output. The output enters a high impedance state when a HIGH-level is applied to the output enable OE

20306

Abstract: KH 151 BK276 JSPHS-26 JSPHS-1000 JSPHS-12 JSPHS-150 JSPHS-446 MPD-21 TTT167
Contextual Info: PHASE DETECTORS Surface Mount ❏ Plug-In & Coaxial HIGH OUTPUT 1000 mV DC output, 1 to 400 MHz SURFACE MOUNT MPD SYPD MODEL NO. RPD ZRPD FREQUENCY POWER SCALE IMPEDANCE ISOLATION OUTPUT MHz IN ohms FACTOR (dB) POLARITY output RF1 load RF2 RF1 RF1-RF2 RF1/RF2

74AHC1G126SE

Abstract: 74AHC1G126 74AHC1G126W5-7 A115-A
Contextual Info: 74AHC1G126 SINGLE BUFFER GATE WITH 3-STATE OUTPUT Description Pin Assignments The 74AHC1G126 is a single non-inverting buffer/bus driver Top View with a 3-state output. The output enters a high impedance state when a LOW-level is applied to the output enable (OE)

mcl mpd-1

Abstract: MCL RPD-1 GG13 mcl rpd mcl mpd-2 MPD-21 TTT167
Contextual Info: PHASE DETECTORS Surface Mount ❏ Plug-In & Coaxial HIGH OUTPUT 1000 mV DC output, 1 to 400 MHz SURFACE MOUNT MPD SYPD FREQUENCY MHz MODEL NO. RF1 RF2 I RPD ZRPD POWER SCALE IMPEDANCE ISOLATION OUTPUT IN ohms FACTOR (dB) POLARITY output RF1 load RF2 RF1-RF2

Contextual Info: 74LVC1G126 SINGLE BUFFER GATE WITH 3-STATE OUTPUT Description Pin Assignments The 74LVC1G126 is a single non-inverting buffer/bus driver Top View with a 3-state output. The output enters a high impedance state when a LOW-level is applied to the output enable (OE)

A115-A

Abstract: DFN1410
Contextual Info: 74LVCE1G125 SINGLE BUFFER GATE WITH 3-STATE OUTPUT Description Pin Assignments Top View The 74LVCE1G125 is a single non-inverting buffer/bus driver with a 3-state output. The output enters a high impedance state when a HIGH-level is applied to the output enable (OE)

Contextual Info: 74AHCT1G126 SINGLE BUFFER GATE WITH 3-STATE OUTPUT Pin Assignments Description The 74AHCT1G126 is a single non-inverting buffer/bus driver Top View with a 3-state output. The output enters a high impedance state when a LOW-level is applied to the output enable (OE)

Contextual Info: 74AHC1G126 SINGLE BUFFER GATE WITH 3-STATE OUTPUT Pin Assignments Description The 74AHC1G126 is a single non-inverting buffer/bus driver Top View with a 3-state output. The output enters a high impedance state when a LOW-level is applied to the output enable (OE)