TRA10 Search Results

TRA1000

Abstract: ti575 charge amplifier Ionization chambers OF TRANSISTOR 2N5485 car rc schematics 2N5485 RS100 SOI series shunt 2n5485 equivalent transistor
Contextual Info: COMPONENTS Monolithic Preamplifier Section 2 TRA1000 CHARGE/CURRENT PULSE PREAMPLIFIER Low Noise Low Cost Low Power Dissipation Versatile Configuration Flexibility Very Wide Dynamic Range Monolithic The LeCroy Model TRA1000 monolithic preamplifier is a versatile,

triac zd 607

Abstract: 1n5204 CA2820 TRW 2N4427 equivalent bfr91 2N6823 842 317 SO8 BD243 PINOUT BD529 bf506 BF845
Contextual Info: MASTER SELECTION GUIDE EUROPEAN SUPPLEMENT This is the European supplement to the USA edition of the Master Selection Guide, SG73/D REV 3. It should be read along with the USA edition. The supplement carries amendments to sections 1 and 5 in the USA edition.

ALI-25

Abstract: ALI-25C SALI-25C ETHERMAP-3 PT, ED. B, 1A 05802
Contextual Info: CUBIT-Pro Device CellBusTM Bus Switch TXC-05802 DATA SHEET DESCRIPTION FEATURES • UTOPIA and 16-Bit ATM or PHY Layer cell interfaces • Inlet-side address translation and routing header insertion, using external SRAM of up to 256 kB • Programmable OAM-cell and RM-cell routing

TRA1000

Abstract: TRE0200 trd04
Contextual Info: TANTALUM LOW ESR SMD CAPACITORS TYPE 522Z Technical Data: All technical data relate to an ambient temperature of +25°C Capacitance Range: 1.5 µF to 470 µF Capacitance Tolerance: ±20%; ±10% Rated Voltage DC VR #+85°C: Category Voltage (VC) #+125°C:

Contextual Info: Tecate Group SURFACE MOUNT TANTALUM LOW ESR TYPE 522Z FEATURES • The six case sizes of the 522Z conform to the sizes most required by the major OEMs throughout Europe and America. These sizes conform to the Electronics Industry Associations of U.S. and Japan recommended

TRA12

Contextual Info: BACK CUBIT-Pro Device CellBusTM Bus Switch TXC-05802 DATA SHEET DESCRIPTION FEATURES • UTOPIA and 16-Bit ATM or PHY or ALI-25 PHY Layer cell interfaces • Inlet-side address translation and routing header insertion, using external SRAM of up to 256 kB

CBD10

Abstract: intel 7882 MARKING 09F PHAST-12E TXC-05802B TXC-05810 TXC-06212 SA 6356
Contextual Info: CUBIT-622 Device Multi-PHY CellBus Access Device TXC-05805 DESCRIPTION • 622 Mbit/s performance • UTOPIA Level 1/2 interface 8/16-bit with support for 64 ports • Tandem operation for two devices, supporting dual CellBus cell switching in load sharing or

Contextual Info: CUBIT-3 Device CellBus Bus Switch TXC-05804 DATA SHEET DESCRIPTION FEATURES CUBIT®-Pro The CUBIT-3 is a single-chip VLSI solution for implementing low-cost ATM multiplexing and switching systems, based on the CellBus® architecture. Such systems are constructed from a number of CUBIT-3 devices, all

A01H

Abstract: 9FF MARKING T-RA18 SA 6356
Contextual Info: CUBIT-622 Device Multi-PHY CellBus Access Device TXC-05805 DESCRIPTION • 622 Mbit/s performance • UTOPIA Level 1/2 interface 8/16-bit with support for 64 ports • Tandem operation for two devices, supporting dual CellBus cell switching in load sharing or

Contextual Info: CUBIT-622 Device DATA SHEET PRODUCT PREVIEW DESCRIPTION FEATURES The CUBIT-622 device is a single-chip solution for implementing low-cost ATM multiplexing and switching systems, based on the CellBus architecture. Such systems are built from a number of CUBIT-3,

Contextual Info: • TRAN ^ k 1004152 0007020 104 ■ CUBIT Device «g*, »* jiüüM R. > ,.M V. CellBus Bus Switch TXC-05801 DATA SHEET DESCRIPTION FEATURES CUBIT is a single-chip solution for implementing low-cost ATM multiplexing and switching systems, based on the CellBus bus architecture. Such systems

TXC-05804-MB

Abstract: sot marking code w17 W17 marking code sot 23
Contextual Info: CUBIT-3 Device CellBus Bus Switch TXC-05804 DATA SHEET CUBIT®-Pro The CUBIT-3™ is a single-chip VLSI solution for implementing low-cost ATM multiplexing and switching systems, based on the CellBus® architecture. Such systems are constructed from a number of CellBus devices, all

Contextual Info: tm ä nx-S w it c h CUBIT-Pro Device S C ellB us Bus Switch TXC-05802B DATA SHEET DESCRIPTION • UTOPIA and 16-Bit ATM or PHY Layer cell in­ terfaces • Inlet-side address translation and routing header insertion, using external SRAM of up to 256 kB

Contextual Info: C U B IT Device C eîîB us Switch TXC-05801 DATA SH EE T FEATURES DESCRIPTION • U TO PIA or A LI-25 physical-layer cell interface C U B IT is a single-chip solution fo r im plem enting low -cost ATM m ultiplexing and sw itching system s, based on the CellBus architecture. Such system s are

picoscope

Abstract: ADC10016 TRA1000 ADC100 ADC-200 labview picoscope ADC10032 adc100w visual basic
Contextual Info: ADC-100 Manual v1.0 1. Introduction 2. Connecting to PC 3. Technical Specifications Writing you own software overview Other Information Safety Warning The maximum input voltage range of the ADC-100 is ±20V. Any voltages in excess of ±100V may cause permanent damage to the unit.

I431

Abstract: TRA12
Contextual Info: CUBIT-3 Device CellBus Bus Switch TXC-05804 DATA SHEET CUBIT®-Pro The CUBIT-3™ is a single-chip VLSI solution for implementing low-cost ATM multiplexing and switching systems, based on the CellBus® architecture. Such systems are constructed from a number of CellBus devices, all

AMP PBT connector 1-965 334-1

Abstract: 13-053 TYCO H05W-F3G1 IEC 60320 OUTLET EN60309 IEC320 C14 Inlet Male Power Socket w Fuse Switch BS5733 din 49440 ASE1011 IEC-309
Contextual Info: 1717 Technical portal and online community for Design Engineers - www.element-14.com Connectors - Power & Mains Page 1719 1744 1728 1736 1744 1734 1727 1735 1728 1729 1732 1731 1744 1733 1736 Adaptors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3F SOT3

Contextual Info: CUBIT-3 Device CellBus Bus Switch TXC-05804 DATA SHEET CUBIT®-Pro The CUBIT-3 is a single-chip VLSI solution for implementing low-cost ATM multiplexing and switching systems, based on the CellBus® architecture. Such systems are constructed from a number of CellBus devices, all

ALI-25

Abstract: ALI-25C circuit diagram of queuing with seven segment
Contextual Info: CUBIT Device CellBus Switch TXC-05801 DATA SHEET FEATURES DESCRIPTION • UTOPIA or ALI-25 physical-layer cell interface • Inlet-side address translation and routing header insertion, using external SRAM • Programmable OAM cell routing • CellBus access request, grant reception and bus

Contextual Info: CUBIT-3 Device CellBus Bus Switch TXC-05804 DATA SHEET FEATURES DESCRIPTION • Interoperable with CUBIT®-Pro TXC-05802B , ASPEN (TXC-05810) UTOPIA Level 2 interface (8/16-bit) with support for 16 ports • Supports dual OC-3 steady state bidirectional

Contextual Info: CUBIT-3 Device CellBus Bus Switch TXC-05804 DATA SHEET FEATURES DESCRIPTION • Interoperable with CUBIT®-Pro TXC-05802B , ASPEN (TXC-05810) UTOPIA Level 2 interface (8/16-bit) with support for 16 ports • Supports dual OC-3 steady state bidirectional

Contextual Info: CUBIT-622 Device DATA SHEET PRODUCT PREVIEW DESCRIPTION FEATURES The CUBIT-622 device is a single-chip solution for implementing low-cost ATM multiplexing and switching systems, based on the CellBus architecture. Such systems are built from a number of CUBIT-3,

Contextual Info: CUBIT-3 Device CellBus Bus Switch TXC-05804 DATA SHEET PRODUCT PREVIEW DESCRIPTION CUBIT®-Pro The CUBIT-3 is a single-chip solution for implementing low-cost ATM multiplexing and switching systems, based on the CellBus® architecture. Such systems are

tantalum 10-35

Abstract: TRA1000 EIA-535BAAC TRA1500
Contextual Info: Tecate Group SURFACE MOUNT TANTALUM LOW ESR TYPE 522Z FEATURES • The six case sizes of the 522Z conform to the sizes most required by the major OEMs throughout Europe and America. These sizes conform to the Electronics Industry Associations of U.S. and Japan recommended