TRANSMISSION LINES TWISTED PAIR SPICE MODEL Search Results

transmission lines Twisted Pair spice model

Abstract: APP4168 AN4168
Contextual Info: Maxim > App Notes > AUTOMATIC TEST EQUIPMENT ATE HIGH-SPEED INTERCONNECT Keywords: transmission line, line impedance, high-speed signal, lossless, lossy, transmission path, source impedance, load, printed circuit board, PCB, micro-strip, coaxial, twisted pair, TDR, Time Domain Reflectometry

transmission lines Twisted Pair spice model

Abstract: transmission lines Twisted Pair characteristics of twisted pair cable LVDS 30 pin connector cable slla053 twisted pair cable with parameter XAPP230 idc 20 pin data ribbon connector receiver LVDS XAPP231
Contextual Info: Application Note: Virtex-E Family The LVDS I/O Standard R XAPP230 v1.1 November 16, 1999 Application Note: Jon Brunetti & Brian Von Herzen Ph.D. Summary This application note describes the LVDS I/O standard. LVDS provides higher noise immunity than single-ended techniques, allowing for higher transmission speeds, smaller signal swings,

Contextual Info: January 2001 CLC001 Serial Digital Cable Driver with Adjustable Outputs General Description Key Specifications The CLC001 is a monolithic, high-speed cable driver designed for use in SMPTE 259M serial digital video and ITU-T G.703 serial digital data transmission applications. The

JCA Technology low noise amplifier

Abstract: jca technology
Contextual Info: CLC450 tß National Semiconductor Comlinear CLC450 Single Supply, Low-Power, High Output, Current Feedback Amplifier General Description Features The Comlinear CLC450 has a new output stage that delivers high output drive current 100mA , but consumes minimal quiescent

CLC452

Abstract: CLC452AJE CLC452AJP C1324 transmission lines Twisted Pair spice model
Contextual Info: CLC452 Single Supply, Low Power, High Output, Current Feedback Amplifier General Description The CLC452 has a new output stage that delivers high output drive current 100mA , but consumes minimal quiescent supply current (3.0mA) from a single 5V supply. Its

CLC450AJM5

Abstract: CLC450 CLC450AJE CLC450AJP spice TRANSFORMER simulation
Contextual Info: CLC450 Single Supply, Low Power, High Output, Current Feedback Amplifier General Description The CLC450 has a new output stage that delivers high output drive current 100mA , but consumes minimal quiescent supply current (1.5mA) from a single 5V supply. Its

DS8820A

Abstract: 7820A
Contextual Info: DS7820A/DS8820A Dual Line Receiver General Description The DS7820A and the DS8820A are improved performance digital line receivers with two completely independent units fabricated on a single silicon chip. Intended for use with digital systems connected by twisted pair lines, they have a differential input designed to reject large common mode signals while responding to small differential signals. The output

DS9638

Contextual Info: DS9638 RS-422 Dual High Speed Differential Line Driver General Description Features The DS9638 is a Schottky, TTL compatible, dual differential line driver designed specifically to meet the EIA Standard RS-422 specifications. It is designed to provide unipolar differential drive to twisted pair or parallel wire transmission

transmission lines Twisted Pair spice model

Abstract: transistor 1N4148 serial data recovery
Contextual Info: CLC012 Adaptive Cable Equalizer for ITU-T G.703 Data Recovery General Description National’s CLC012 adaptive cable equalizer is a low-cost monolithic solution for equalizing data transmitted over cable or any media with similar dispersive loss characteristics .

transmission lines Twisted Pair spice model

Abstract: MMBD701 Twisted Pair split termination 100EP MBD301 MBD701 MC10EP16 MMBD301 diode z01
Contextual Info: AND8020/D Termination of ECL Devices with EF Emitter Follower OUTPUT Structure Prepared by: Paul Shockman ON Semiconductor Logic Applications Engineering http://onsemi.com APPLICATION NOTE CONTENTS OF APPLICATION NOTE Introduction − DC Termination Analysis

transmission lines Twisted Pair spice model

Abstract: Twisted Pair split termination MC10EP16 0.001 MF CAPACITOR
Contextual Info: AND8020/D Termination of ECL Logic Devices with EF Emitter Follower OUTPUT Structure http://onsemi.com Prepared by: Paul Shockman ON Semiconductor Logic Applications Engineering APPLICATION NOTE CONTENTS OF APPLICATION NOTE Introduction − DC Termination Analysis

rsn 3305

Abstract: transmission lines Twisted Pair spice model MC10EP16 100EP 0.001 MF CAPACITOR AND8020
Contextual Info: AND8020/D Termination of ECL Logic Devices Prepared by: Paul Shockman ON Semiconductor Logic Applications Engineering http://onsemi.com APPLICATION NOTE CONTENTS OF APPLICATION NOTE Introduction – DC Termination Analysis Section 3. Thevenin Equivalent/Parallel Termination

pm 8921

Abstract: DS892 DS8921AN
Contextual Info: DS8921/DS8921A/DS8921AT Differential Line Driver and Receiver Pair General Description The DS8921, DS8921A are Differential Line Driver and Receiver pairs designed specifically for applications meeting the ST506, ST412 and ESDI Disk Drive Standards. In addition, these devices meet the requirements of the EIA Standard RS-422.

DS8922AN

Abstract: DS8923AM
Contextual Info: DS8922/DS8922A/DS8923A TRI-STATE RS-422 Dual Differential Line Driver and Receiver Pairs General Description The DS8922/22A and DS8923A are Dual Differential Line Driver and Receiver pairs. These devices are designed specifically for applications meeting the ST506, ST412 and

CSA907T

Abstract: transistor 1N4148
Contextual Info: CLC014 Adaptive Cable Equalizer for High-Speed Data Recovery General Description National’s CLC014 adaptive cable equalizer is a low-cost monolithic solution for equalizing data transmitted over cable or any media with similar dispersive loss characteristics .

CLC450

Abstract: CLC450AJ CLC450AJE CLC450AJM5 CLC450AJP CLC450ALC
Contextual Info: N CLC450 Single Supply, Low-Power, High Output, Current Feedback Amplifier General Description Features The CLC450 has a new output stage that delivers high output drive current 100mA , but consumes minimal quiescent supply current (1.5mA) from a single 5V supply. Its current feedback

Contextual Info: CLC452 CLC452 Single Supply, Low Power, High Output, Current Feedback Amplifier Literature Number: SNOS865B CLC452 Single Supply, Low Power, High Output, Current Feedback Amplifier General Description The CLC452 has a new output stage that delivers high output drive current 100mA , but consumes minimal

Contextual Info: CLC450 CLC450 Single Supply, Low Power, High Output, Current Feedback Amplifier Literature Number: SNOS840B CLC450 Single Supply, Low Power, High Output, Current Feedback Amplifier General Description The CLC450 has a new output stage that delivers high output drive current 100mA , but consumes minimal

CLC450

Abstract: CLC450AJ CLC450AJE CLC450AJM5 CLC450AJP CLC450ALC spice TRANSFORMER simulation
Contextual Info: N CLC450 Single Supply, Low-Power, High Output, Current Feedback Amplifier General Description Features The CLC450 has a new output stage that delivers high output drive current 100mA , but consumes minimal quiescent supply current (1.5mA) from a single 5V supply. Its current feedback

CLC452

Abstract: CLC452AJ CLC452AJE CLC452AJM5 CLC452AJP CLC452ALC transmission lines Twisted Pair spice model 24haa
Contextual Info: D ecem ber 1996 N atio n al Semiconductor & Comlinear CLC452 Single Supply, Low-Power, High Output, Current Feedback Amplifier General Description Features The Comlinear CLC452 has a new output stage that delivers high output drive current 100mA , but consumes minimal quiescent

CLC453AJE

Abstract: Transistor AC 51 CLC453 CLC453AJM5 CLC453AJP CLC453ALC
Contextual Info: National Semiconductor f 3 (Q (D & cn £ T3 •Ö Comlinear CLC453 Single Supply, Low-Power, High Output, Programmable Buffer General Description Features The Comlinear CLC453 is a low cost, high speed (110MHz) buffer that features user-programmable gains of +2, +1, and

Contextual Info: September 1998 National e Sem iconductor 0 0 Q O ? CLC453 Single Supply, Low-Power, High Output, Programmable Buffer General Description Features The CLC453 is a low cost, high speed (110MHz) buffer that fea­ tures user-programmable gains of +2, +1, and -1V/V. It has a

5ypp

Abstract: op closed-loop 60MHZ 25X1 CLC451 CLC451AJ CLC451AJE CLC451AJM5 CLC451AJP CLC451ALC
Contextual Info: April 1998 National / o 5 ' r; Semiconductor <Q O & ST ^ cd IT) - L CLC451 Single Supply, Low-Power, High Output, Programmable Buffer General Description Features The CLC451 is a low cost, high speed (85MHz) buffer that features user-programmable gains of +2, +1, and -1VAf. It has a

CLC450

Abstract: CLC451 CLC451AJ CLC451AJE CLC451AJM5
Contextual Info: N ational f 3 Semiconductor (Q (D & cn £ T3 •Ö Comlinear CLC451 Single Supply, Low-Power, High Output, Programmable Buffer General Description Features The Comlinear CLC451 is a low cost, high speed (85MHz) buffer that features user-programmable gains of +2, +1, and