The recommended operating voltage range for the 74V1G70CTR is 1.65V to 5.5V, as specified in the datasheet. However, it's recommended to operate the device within the 2.3V to 5.5V range for optimal performance and to ensure that the output voltage swing is sufficient to drive the load.
It's recommended to follow a controlled power-up and power-down sequence to prevent unwanted output transitions and ensure proper device operation. A recommended sequence is to power up the VCC pin first, followed by the input signals, and then power down the input signals before powering down the VCC pin.
The maximum frequency of operation for the 74V1G70CTR is not explicitly stated in the datasheet. However, based on the device's propagation delay and rise/fall times, it's recommended to operate the device at frequencies up to 100MHz for optimal performance.
To prevent signal reflections, it's recommended to terminate the output pins of the 74V1G70CTR with a 50Ω resistor to ground, or to use a termination scheme that matches the impedance of the transmission line. Additionally, ensure that the PCB layout is designed to minimize signal reflections and crosstalk.
The recommended input signal slew rate for the 74V1G70CTR is not explicitly stated in the datasheet. However, as a general rule, it's recommended to keep the input signal slew rate below 10V/ns to ensure proper device operation and prevent unwanted output transitions.
74V1G70CTR datasheet
by STMicroelectronics
Findchips
Findchips