ADS1015IDGSR datasheet by Texas Instruments

ADS1015IDGSR Frequently Asked Questions (FAQs)

• What is the maximum sampling rate of the ADS1015?
  The maximum sampling rate of the ADS1015 is 3300 samples per second (SPS) for a single channel, and 1500 SPS for multiple channels.
• How do I configure the gain settings for the ADS1015?
  The gain settings for the ADS1015 can be configured using the PGA (Programmable Gain Amplifier) bits in the Config Register. The gain can be set to 2/3, 1, 2, 4, 8, or 16.
• What is the purpose of the DRDY pin on the ADS1015?
  The DRDY (Data Ready) pin is an output pin that goes low when a conversion is complete and the data is ready to be read. It can be used to interrupt the microcontroller to read the data.
• How do I handle the noise and interference in the ADS1015?
  To handle noise and interference in the ADS1015, use a low-pass filter on the input signals, ensure proper grounding and shielding, and consider using a ferrite bead or common-mode choke on the input lines.
• What is the power consumption of the ADS1015?
  The power consumption of the ADS1015 is typically 150 μA at 3.3 V and 1 MSPS, but it can vary depending on the sampling rate and other factors.