A 4-layer PCB with a solid ground plane and a separate power plane is recommended. The device should be placed near the edge of the board to minimize signal reflections. A 50-ohm microstrip transmission line should be used to connect the device to the antenna.
The device requires a single 3.3V power supply. A 10uF capacitor should be connected between the VCC pin and ground to filter out noise. A 1kohm resistor should be connected between the EN pin and VCC to enable the device.
The device is rated for operation from -40°C to 85°C. However, the optimal operating temperature range is from 0°C to 70°C for maximum performance and reliability.
Use a spectrum analyzer to check the transmitted signal spectrum and ensure it meets the required specifications. Check the device's power supply and biasing to ensure they are within the recommended range. Use a logic analyzer to verify the device's control signals.
Yes, multiple AFBR-2310Z devices can be used in a multi-device configuration. However, each device should have its own power supply and biasing circuitry. The devices should be spaced at least 10mm apart to minimize electromagnetic interference.
Findchips
Findchips