A good PCB layout for the APDS-9700-020 involves keeping the sensor away from high-frequency components, using a solid ground plane, and minimizing the distance between the sensor and the MCU. A 4-layer PCB with a dedicated ground plane is recommended.
Calibration involves adjusting the sensitivity of the sensor to the specific application's lighting conditions. This can be done by taking multiple readings at different light levels and adjusting the gain settings accordingly. The APDS-9700-020 also has a built-in calibration feature that can be used.
The maximum distance between the APDS-9700-020 and the MCU depends on the specific application and the type of interface used (I2C or SPI). As a general rule, it's recommended to keep the distance as short as possible (less than 10 cm) to minimize signal degradation and noise.
The APDS-9700-020 generates interrupts when the ambient light level exceeds a certain threshold. To handle these interrupts, the MCU should be configured to detect the interrupt signal and execute the corresponding interrupt service routine (ISR) to read the sensor data and take appropriate action.
The power consumption of the APDS-9700-020 depends on the operating mode and the frequency of measurements. In low-power mode, the typical current consumption is around 1.5 μA, while in high-power mode, it's around 150 μA.
APDS-9700-020 datasheet
by Avago Technologies
Findchips
