The maximum operating frequency of the CY7C63723-SC is 67 MHz, but it can be overclocked to 80 MHz with some limitations.
The CY7C63723-SC has a built-in FIFO buffer, but it requires external logic to implement a full-featured FIFO. You can use the device's internal registers and flags to create a FIFO buffer, or use an external FIFO IC.
Yes, the CY7C63723-SC can be used as a UART bridge, but it requires external logic to handle the UART protocol. The device has a built-in UART interface, but it's limited to 115.2 kbps and doesn't support advanced UART features.
To configure the CY7C63723-SC for I2C mode, you need to set the MODE pin high and configure the I2C clock frequency using the internal clock generator. You also need to configure the I2C address using the ADD[2:0] pins.
The maximum cable length supported by the CY7C63723-SC depends on the operating frequency and the type of cable used. As a general rule, the maximum cable length is around 3-5 meters at 67 MHz, but it can be extended using repeaters or active cables.