a fixed frequency oscillator requiring no external components for operation. Numerous set operating frequencies are possible in the range 29.2 kHz to 100 MHz.
Maxim provides a layout and routing guide in their application note AN1971, which recommends using a 4-layer PCB with a solid ground plane, keeping the input and output traces short and away from each other, and using a common-mode choke to reduce EMI.
The DS1073M-66 requires a stable power supply with a minimum of 3.3V and a maximum of 5.5V. It's recommended to use a low-ESR capacitor (e.g. 10uF) between VCC and GND, and to decouple the power supply lines with a 10nF capacitor. Additionally, a 1uF capacitor between VCC and AVCC is recommended for analog power supply decoupling.
The DS1073M-66 can operate up to a maximum clock frequency of 66MHz, but the actual frequency limit may depend on the specific application and PCB layout. It's recommended to consult the datasheet and application notes for more information on clock frequency limitations.
The DS1073M-66's internal registers can be programmed using the I2C interface. The device has a 7-bit slave address, and the registers can be accessed using the I2C write and read commands. The register map and programming details can be found in the datasheet and application notes.
The typical power consumption of the DS1073M-66 is around 15mA at 3.3V and 25°C, but this can vary depending on the specific application, clock frequency, and operating conditions. The datasheet provides more information on power consumption and power-down modes.
DS1073M-66 datasheet
by Maxim Integrated Products
