The DS1230Y-100 is a sensitive device and requires careful layout and placement to ensure proper operation. It is recommended to place the device close to the battery, use short traces, and avoid routing signals under the device. Additionally, a solid ground plane under the device can help reduce noise and improve performance.
The reset pin (RST) should be tied to VCC through a pull-up resistor (typically 1kΩ to 10kΩ) to ensure a clean reset during power-up. During power-down, the RST pin should be pulled low to ensure a clean shutdown. It is also recommended to add a capacitor (typically 0.1μF to 1μF) between RST and GND to filter out noise.
The DS1230Y-100 is designed to work with a wide range of battery types, including alkaline, nickel-cadmium (Ni-Cd), and nickel-metal hydride (NiMH) batteries. The recommended battery configuration is a single-cell battery with a voltage range of 2.7V to 3.6V. It is also recommended to use a battery with a low self-discharge rate to ensure long-term reliability.
The DS1230Y-100 has a built-in low-battery detection feature that can be enabled by connecting the LB pin to a resistor divider network. The resistor divider network should be designed to detect a voltage threshold of around 2.5V to 2.7V, depending on the specific battery type and application requirements.
The DS1230Y-100 has an operating temperature range of -40°C to +85°C. However, it is recommended to operate the device within a temperature range of 0°C to +70°C for optimal performance and reliability.
DS1230Y-100 datasheet
by Maxim Integrated Products
Findchips
Findchips