Maxim provides a layout and routing guide in their application note AN1441, which recommends a 4-layer PCB with a solid ground plane, and careful routing of the clock and data lines to minimize noise and crosstalk.
The DS1833-10/T&R requires a 3.3V power supply, and it's recommended to use a low-ESR capacitor (e.g. 0.1uF) for power supply decoupling, and a 10uF capacitor for bulk capacitance. Additionally, a 0.01uF capacitor should be used to bypass the VCC pin to GND.
The DS1833-10/T&R can support clock frequencies up to 100MHz, but it's recommended to limit the clock frequency to 50MHz or less to ensure reliable operation and minimize power consumption.
To use an external clock source, the EXTCLK pin should be connected to the external clock signal, and the CLKSEL pin should be tied to VCC. The external clock frequency should be within the specified range of 1MHz to 100MHz.
The typical power consumption of the DS1833-10/T&R is around 15mA at 3.3V and 50MHz clock frequency, but it can vary depending on the specific application and operating conditions.
DS1833-10/T&R datasheet
by Maxim Integrated Products
Findchips
Findchips