LT3010EMS8E datasheet by Linear Technology

LT3010EMS8E Frequently Asked Questions (FAQs)

• What is the maximum output current of the LT3010EMS8E?
  The maximum output current of the LT3010EMS8E is 1.5A. However, it's recommended to limit the output current to 1A for optimal performance and reliability.
• How do I ensure the stability of the output voltage?
  To ensure the stability of the output voltage, it's essential to use a minimum output capacitance of 10uF with an ESR of 1ohm or less. Additionally, the output capacitor should be placed as close to the output pin as possible.
• What is the purpose of the EN pin, and how do I use it?
  The EN (enable) pin is used to turn the regulator on or off. To enable the regulator, connect the EN pin to VIN or a logic high signal. To disable the regulator, connect the EN pin to GND or a logic low signal.
• How do I adjust the output voltage of the LT3010EMS8E?
  The output voltage of the LT3010EMS8E can be adjusted by using an external resistor divider network between the output pin and the ADJ pin. The output voltage is determined by the ratio of the resistors and the internal reference voltage.
• What is the thermal shutdown threshold of the LT3010EMS8E?
  The thermal shutdown threshold of the LT3010EMS8E is typically 150°C. When the junction temperature exceeds this threshold, the regulator will shut down to prevent damage.