The recommended layout and placement for the MAX11116AUT+T involves keeping the analog and digital grounds separate, using a solid ground plane, and placing the device close to the analog signal sources. Additionally, it's recommended to use a 4-layer PCB with a dedicated analog power plane and a dedicated digital power plane.
To optimize the performance of the MAX11116AUT+T in noisy environments, use a low-pass filter on the analog input, use a shielded cable for the analog input, and keep the device away from high-frequency sources. Additionally, consider using a ferrite bead on the power supply line to reduce high-frequency noise.
The maximum sampling rate that can be achieved with the MAX11116AUT+T is 1Msps (1 million samples per second) in the fast mode, and 500ksps (500 thousand samples per second) in the normal mode.
The MAX11116AUT+T does not require calibration. It has an internal calibration circuit that calibrates the device during power-up. However, if the device is used in an application that requires high accuracy, an external calibration circuit can be used to improve the accuracy.
The power consumption of the MAX11116AUT+T depends on the operating mode. In the normal mode, the power consumption is typically around 1.5mA, and in the shutdown mode, the power consumption is typically around 1μA.
Findchips
