The recommended PCB layout for the MAX16046ECB+ is to keep the input and output traces as short as possible, and to use a solid ground plane to reduce noise and EMI. Additionally, it's recommended to place a 10uF capacitor between the VIN and GND pins to filter out noise.
To ensure proper power-up and power-down of the MAX16046ECB+, it's recommended to follow a specific power-up sequence: first, apply VIN, then enable the EN pin, and finally, apply the input voltage to the IN pin. During power-down, reverse this sequence.
The maximum input voltage that can be applied to the MAX16046ECB+ is 5.5V. Exceeding this voltage may damage the device.
The output voltage of the MAX16046ECB+ can be calculated using the following formula: VOUT = (VIN x (R1 + R2) / R2) + VREF, where R1 and R2 are the resistors used in the feedback network, and VREF is the internal reference voltage (typically 1.25V).
The typical quiescent current of the MAX16046ECB+ is around 20uA, but this can vary depending on the input voltage, output voltage, and other operating conditions.
MAX16046ECB+ datasheet
by Maxim Integrated Products
