MAX17048X+ datasheet by Maxim Integrated Products

MAX17048X+ Frequently Asked Questions (FAQs)

• What is the recommended layout and placement for the MAX17048X+?
  The MAX17048X+ requires careful layout and placement to ensure accurate fuel gauge measurements. It is recommended to place the device close to the battery, use a solid ground plane, and keep the sense lines short and away from noise sources.
• How do I calibrate the MAX17048X+ for my specific battery chemistry?
  Calibration involves setting the device's internal registers to match the battery's characteristics. This can be done using the MAX17048X+ evaluation kit and software, or by following the calibration procedure outlined in the datasheet.
• What is the impact of temperature on the MAX17048X+ accuracy?
  Temperature affects the accuracy of the MAX17048X+. The device has a built-in temperature sensor, and the datasheet provides temperature compensation formulas to ensure accurate measurements across a wide temperature range.
• How do I handle the MAX17048X+ in a low-power or sleep mode?
  The MAX17048X+ has a low-power mode that reduces current consumption. To enter low-power mode, set the SHDN pin high and ensure the device is not performing any measurements. Wake-up from low-power mode is achieved by setting the SHDN pin low.
• What is the maximum allowed voltage on the VCC pin?
  The maximum allowed voltage on the VCC pin is 3.6V. Exceeding this voltage may damage the device. It is recommended to use a voltage regulator or a voltage limiter to ensure the VCC pin voltage remains within the specified range.