The MAX202EWE is a high-speed device, and proper layout and routing are crucial to minimize EMI and noise. It is recommended to follow the layout guidelines provided in the application note AN1541, which includes tips on component placement, trace routing, and grounding.
Proper termination is critical for high-speed signals. The MAX202EWE requires a 50Ω termination resistor on the output pins (RX+/RX-) to match the impedance of the transmission line. Additionally, the input pins (TX+/TX-) should be terminated with a 50Ω resistor to ground to prevent signal reflections.
The maximum cable length supported by the MAX202EWE depends on the specific application and the type of cable used. However, as a general guideline, the MAX202EWE can support cable lengths up to 10 meters (33 feet) at data rates up to 100 Mbps. For longer cable lengths or higher data rates, repeaters or active cables may be required.
The MAX202EWE has built-in hot-swap and plug-and-play capabilities. To ensure reliable operation, it is recommended to follow the guidelines provided in the application note AN1541, which includes tips on power sequencing, signal routing, and connector selection.
The MAX202EWE has a maximum junction temperature of 150°C. To ensure proper heat dissipation, it is recommended to follow the thermal guidelines provided in the datasheet, which include tips on PCB layout, thermal vias, and heat sink selection. Additionally, the device should be operated within the recommended operating temperature range of -40°C to 85°C.
MAX202EWE datasheet
by Maxim Integrated Products
