Please enter a valid full or partial manufacturer part number with a minimum of 3 letters or numbers

    MAX5802AAUB+T datasheet by Maxim Integrated Products

    • Data Acquisition - Digital to Analog Converters (DAC), Integrated Circuits (ICs), IC DAC 12BIT I2C DUAL LP 10UMAX
    • Original
    • Yes
    • Obsolete
    • 8542.39.00.01
    • 8542.39.00.00
    • Powered by Findchips Logo Findchips

    MAX5802AAUB+T datasheet preview

    MAX5802AAUB+T Frequently Asked Questions (FAQs)

    • The recommended PCB layout for the MAX5802AAUB+T involves keeping the input and output traces as short as possible, using a solid ground plane, and placing the input and output capacitors close to the device. Additionally, it's recommended to use a 4-layer PCB with a dedicated power plane and a dedicated ground plane to minimize noise and ensure optimal performance.
    • The output capacitor selection for the MAX5802AAUB+T depends on the output voltage, output current, and desired ripple voltage. A general rule of thumb is to choose a capacitor with a capacitance value of at least 10uF and a voltage rating of at least 1.5 times the output voltage. Additionally, the capacitor's ESR (Equivalent Series Resistance) should be less than 1 ohm to ensure stability.
    • The MAX5802AAUB+T has an operating temperature range of -40°C to +125°C, but the maximum ambient temperature range depends on the specific application and the device's power dissipation. As a general rule, the ambient temperature should be kept below 85°C to ensure reliable operation.
    • To ensure proper power-up and power-down of the MAX5802AAUB+T, it's recommended to follow a soft-start sequence, where the input voltage is ramped up slowly to prevent inrush currents. Additionally, the enable pin should be driven high after the input voltage has reached its nominal value. During power-down, the enable pin should be driven low before the input voltage is reduced.
    • The recommended input capacitor value for the MAX5802AAUB+T depends on the input voltage, input current, and desired ripple voltage. A general rule of thumb is to choose a capacitor with a capacitance value of at least 1uF and a voltage rating of at least 1.5 times the input voltage. Additionally, the capacitor's ESR should be less than 1 ohm to ensure stability.
    Supplyframe Tracking Pixel