The MAX6160EUS is a high-frequency device, so it's essential to follow good layout and placement practices to minimize noise and ensure proper operation. Maxim recommends keeping the device close to the power source, using short traces, and avoiding vias under the device. A solid ground plane and decoupling capacitors are also crucial.
The output filter design for the MAX6160EUS depends on the specific application requirements. However, as a general rule, Maxim recommends using a low-pass filter with a cutoff frequency below 100 kHz to minimize high-frequency noise. The filter components should be chosen to provide a high impedance at the switching frequency and a low impedance at the output frequency.
The MAX6160EUS has an absolute maximum input voltage rating of 6.5V. However, the recommended operating input voltage range is 4.5V to 5.5V. Exceeding the maximum input voltage can damage the device.
To ensure stability, Maxim recommends following the recommended component values and layout guidelines in the datasheet. Additionally, the input and output capacitors should be chosen to provide sufficient decoupling and filtering. It's also essential to ensure that the device is properly bypassed and that the power supply is clean and stable.
The MAX6160EUS has a thermal derating of 12.5mW/°C above 25°C. This means that the device's power dissipation should be reduced as the ambient temperature increases to prevent overheating and ensure reliable operation.
MAX6160EUS datasheet
by Maxim Integrated Products
Findchips
