The recommended layout and routing for the MAX708TCUA+T involves keeping the input and output traces short and away from each other, using a solid ground plane, and avoiding vias and right-angle turns. Additionally, it's recommended to use a 0.1uF bypass capacitor between VCC and GND, and to keep the power supply decoupling capacitors close to the device.
To ensure proper power-up and initialization, the MAX708TCUA+T requires a stable power supply voltage between 2.7V and 5.5V, and a clock signal with a frequency between 32.768kHz and 1MHz. The device also requires a reset signal (RST) to be pulled low for at least 10ns to initialize the device.
The MAX708TCUA+T can support clock frequencies up to 1MHz, but it's recommended to use a clock frequency of 32.768kHz for optimal performance and to minimize power consumption.
The MAX708TCUA+T has a 3-wire serial interface (SCL, SDA, and RST) that can be connected to a microcontroller or other digital devices. The device uses the I2C protocol for communication, and the microcontroller can act as the master device to read and write data to the MAX708TCUA+T.
The typical power consumption of the MAX708TCUA+T is around 1.5uA in active mode and 0.5uA in standby mode, making it suitable for battery-powered applications.
MAX708TCUA+T datasheet
by Maxim Integrated Products
