The MAX808LCSA+ is a sensitive device and requires careful layout and placement to ensure optimal performance. It is recommended to place the device close to the power source, use a solid ground plane, and keep the input and output traces short and separate to minimize noise and EMI. Additionally, it is recommended to use a 0.1uF bypass capacitor between the VIN pin and GND to filter out high-frequency noise.
The MAX808LCSA+ has a specific power-up sequence requirement to ensure proper operation. It is recommended to power up the device in the following sequence: GND, VIN, and then EN. This sequence ensures that the internal voltage regulators are properly initialized and the device is configured correctly.
The MAX808LCSA+ can handle input voltages up to 12V, but it is recommended to operate the device within the specified input voltage range of 2.7V to 5.5V to ensure optimal performance and reliability.
The output voltage of the MAX808LCSA+ can be adjusted by connecting a resistive divider network between the OUT pin and GND. The output voltage is determined by the ratio of the resistors in the divider network. It is recommended to use 1% tolerance resistors to ensure accurate output voltage regulation.
The MAX808LCSA+ can provide a maximum output current of 150mA. However, it is recommended to operate the device within the specified output current range of 10mA to 100mA to ensure optimal performance and reliability.
MAX808LCSA+ datasheet
by Maxim Integrated Products
Findchips
