The recommended operating voltage range for MSP430F2013 is 1.8V to 3.6V. However, it can operate from 1.4V to 3.6V, but with reduced performance and accuracy.
To configure the MSP430F2013 for low power consumption, use the low-power modes (LPM0-LPM4) by setting the corresponding bits in the status register (SR). Additionally, disable unused peripherals, use a low-frequency clock, and optimize the code for low power consumption.
The maximum clock frequency supported by MSP430F2013 is 16 MHz. However, it can be operated at frequencies up to 20 MHz, but with reduced performance and accuracy.
The MSP430F2013 can be programmed using the Spy-Bi-Wire (SBW) interface or the JTAG interface. You can use the Texas Instruments Code Composer Studio (CCS) or IAR Embedded Workbench to develop and debug your code.
The RST/NMI pin on the MSP430F2013 is a dual-function pin that can be used as either a reset pin or a non-maskable interrupt (NMI) pin. When connected to VCC, it acts as a reset pin, and when connected to a logic low signal, it acts as an NMI pin.
MSP430F2013QRSATEP datasheet
by Texas Instruments
