The maximum operating temperature range for the S29GL256S10DHI020 is -40°C to +85°C.
The HOLD# signal should be asserted low to pause the current operation and de-asserted high to resume the operation. During the hold state, the device will tri-state its outputs and ignore any input signals.
The recommended power-up sequence is to apply VCC first, followed by VCCQ, and then the clock signal. This ensures that the device is properly initialized and ready for operation.
The device density and configuration can be determined by reading the device ID and configuration registers. The device ID is read using the JEDEC ID command (0x9F), and the configuration registers are read using the Read Configuration Register command (0x35).
The Write Enable Latch (WEL) bit is used to enable or disable write operations to the device. When WEL is set to 1, write operations are enabled, and when WEL is set to 0, write operations are disabled.
