The maximum operating frequency of the S29JL032J70BHI310 is 133 MHz.
The HOLD# signal should be asserted low to pause the flash operation, and de-asserted high to resume the operation.
The WP# pin is used to prevent accidental writes to the flash memory. When WP# is low, the flash memory is write-protected.
To perform a sector erase operation, send the erase command (0x20) followed by the sector address to be erased. The device will then erase the entire sector.
The recommended power-up sequence is to apply VCC first, followed by VPP (if used), and then the clock signal.
