The recommended operating voltage range for SC68C94A1A is 4.5V to 5.5V, with a typical voltage of 5V.
The reset pin (RST) should be pulled high during power-up to ensure proper initialization. A 10kΩ pull-up resistor is recommended.
The maximum clock frequency supported by SC68C94A1A is 16 MHz.
The UART baud rate can be configured using the UART Control Register (UCR). The baud rate is determined by the clock frequency and the divisor value set in the UCR.
The watchdog timer (WDT) is used to reset the microcontroller in case of a software or hardware failure. It can be enabled or disabled using the WDT Control Register (WDTCR).
