The maximum cable length supported by the SN65HVD3088ED is dependent on the specific application and the type of cable used. However, as a general guideline, the device can support cable lengths of up to 100 meters at a data rate of 100 Mbps.
The SN65HVD3088ED can be configured for half-duplex or full-duplex operation by setting the HDX pin high or low, respectively. When the HDX pin is high, the device operates in half-duplex mode, and when it is low, the device operates in full-duplex mode.
The SN65HVD3088ED supports data rates of up to 100 Mbps.
Fault tolerance can be implemented in a system using the SN65HVD3088ED by using redundant transceivers and implementing a fault detection mechanism. The device also has built-in fault detection capabilities, such as the FAULT pin, which can be used to detect faults in the system.
The power consumption of the SN65HVD3088ED is typically around 150 mA at 3.3 V, but this can vary depending on the specific application and operating conditions.
SN65HVD3088ED datasheet
by Texas Instruments
