SN65LVDS33MDREP datasheet by Texas Instruments

SN65LVDS33MDREP Frequently Asked Questions (FAQs)

• What is the maximum cable length supported by the SN65LVDS33MDREP?
  The maximum cable length supported by the SN65LVDS33MDREP is approximately 10 meters (33 feet) at a data rate of 655 Mbps. However, this length can vary depending on the specific application, cable quality, and noise environment.
• How do I terminate the differential pairs in the SN65LVDS33MDREP?
  The SN65LVDS33MDREP requires a 100-ohm differential termination resistor at the receiver end to ensure signal integrity. The termination resistor should be placed as close to the receiver as possible.
• What is the power consumption of the SN65LVDS33MDREP?
  The power consumption of the SN65LVDS33MDREP is approximately 135 mW (typical) at a supply voltage of 3.3 V and a data rate of 655 Mbps. However, this value can vary depending on the specific application and operating conditions.
• Can I use the SN65LVDS33MDREP for high-speed data transmission over long distances?
  Yes, the SN65LVDS33MDREP is designed for high-speed data transmission over long distances. It supports data rates up to 655 Mbps and is suitable for applications such as flat-panel displays, kiosks, and industrial control systems.
• How do I ensure electromagnetic compatibility (EMC) with the SN65LVDS33MDREP?
  To ensure EMC with the SN65LVDS33MDREP, follow proper PCB design and layout guidelines, use shielding and grounding techniques, and ensure that the device is properly decoupled from the power supply. Additionally, follow the guidelines outlined in the Texas Instruments application note 'EMC Design Considerations for LVDS Interfaces'.