The maximum cable length supported by the SN65LVDS387DGGG is dependent on the specific application and the type of cable used. However, as a general guideline, Texas Instruments recommends a maximum cable length of 10 meters for a single-ended signal and 20 meters for a differential signal.
To ensure signal integrity with the SN65LVDS387DGGG, it is recommended to follow proper PCB design and layout guidelines, such as using differential pairs, minimizing trace length and impedance mismatch, and using termination resistors. Additionally, the use of a common-mode filter or a shielded cable can help to reduce electromagnetic interference (EMI).
The power consumption of the SN65LVDS387DGGG is dependent on the specific application and the operating conditions. However, according to the datasheet, the typical power consumption is around 150 mW at a supply voltage of 3.3 V and a data rate of 1.5 Gbps.
Yes, the SN65LVDS387DGGG can be used in a multi-point bus configuration. However, it is recommended to use a repeater or a buffer to ensure signal integrity and to prevent signal degradation due to the loading effects of multiple receivers.
The SN65LVDS387DGGG supports data rates up to 1.5 Gbps. However, the actual data rate may be limited by the specific application, the quality of the transmission channel, and the receiver's capability.
SN65LVDS387DGGG4 datasheet
by Texas Instruments
