SN74ALVC16835DGVR datasheet by Texas Instruments

SN74ALVC16835DGVR Frequently Asked Questions (FAQs)

• What is the recommended operating voltage range for the SN74ALVC16835DGVR?
  The recommended operating voltage range for the SN74ALVC16835DGVR is 1.65V to 3.6V.
• How do I ensure signal integrity when using the SN74ALVC16835DGVR in a high-speed application?
  To ensure signal integrity, use a low-impedance PCB design, keep signal traces short, and use termination resistors as needed. Also, consider using a signal integrity analysis tool to simulate and optimize your design.
• Can I use the SN74ALVC16835DGVR in a 5V system?
  While the SN74ALVC16835DGVR is rated for 1.65V to 3.6V operation, it can tolerate 5V input signals. However, the output voltage will be limited to the supply voltage (VCC). If you need 5V output levels, consider using a level translator or a different device.
• How do I handle power sequencing when using the SN74ALVC16835DGVR in a system with multiple power rails?
  To avoid latch-up or other issues, ensure that the VCC pin is powered up before the input signals. Also, consider using a power sequencing controller or a reset signal to ensure proper power-up and power-down sequences.
• What is the maximum clock frequency supported by the SN74ALVC16835DGVR?
  The maximum clock frequency supported by the SN74ALVC16835DGVR is 100 MHz. However, this may vary depending on the specific application, PCB design, and operating conditions.