SN74LVTH16501DGGR datasheet by Texas Instruments

SN74LVTH16501DGGR Frequently Asked Questions (FAQs)

• What is the recommended operating voltage range for the SN74LVTH16501DGGR?
  The recommended operating voltage range for the SN74LVTH16501DGGR is 2.3V to 3.6V, with a typical voltage of 3.3V.
• How do I ensure signal integrity when using the SN74LVTH16501DGGR in a high-speed application?
  To ensure signal integrity, use a low-impedance PCB design, keep signal traces short and away from noise sources, and use termination resistors as needed. Additionally, consider using a signal integrity analysis tool to simulate and optimize your design.
• Can I use the SN74LVTH16501DGGR in a 5V system?
  While the SN74LVTH16501DGGR is designed for 3.3V operation, it can tolerate 5V inputs with some limitations. However, it's not recommended to operate the device at 5V continuously, as it may exceed the maximum rating and affect reliability. If you need to interface with 5V logic, consider using a level translator or voltage regulator.
• How do I handle power sequencing when using the SN74LVTH16501DGGR in a complex system?
  To ensure proper operation, power up the VCC pin before applying any input signals. Also, ensure that the power supply is stable and within the recommended operating range before enabling the device. Consider using a power sequencing controller or a reset circuit to manage power-up and power-down sequences.
• What is the maximum clock frequency supported by the SN74LVTH16501DGGR?
  The SN74LVTH16501DGGR can operate at clock frequencies up to 100 MHz, but the actual frequency limit may depend on the specific application, PCB design, and signal quality. Consult the datasheet and application notes for more information on clock frequency limitations.