The recommended power-up sequence is to first power up the analog supply (AVDD), followed by the digital supply (DVDD), and then the clock signal (MCLK). This ensures proper initialization of the device.
The TAS5760LDAP can be configured for mono or stereo operation by setting the MONO pin high or low, respectively. In mono mode, the left and right channels are summed and output on both channels. In stereo mode, the left and right channels are output separately.
The maximum input signal amplitude that the TAS5760LDAP can handle is 2.5Vrms. Exceeding this amplitude may result in distortion or clipping of the output signal.
The gain of the TAS5760LDAP can be adjusted by setting the GAIN pin to a specific voltage level. The gain range is from -12dB to +12dB in 1dB steps. The gain setting is stored in an internal register and can be programmed through the I2C interface.
The SOFT_RST pin is used to reset the TAS5760LDAP without powering it down. When the SOFT_RST pin is asserted, the device resets its internal registers and returns to its default state. This can be useful for recovering from errors or initializing the device after a power-up sequence.
TAS5760LDAP datasheet
by Texas Instruments
Findchips
