TMS320C50PGE datasheet by Texas Instruments

TMS320C50PGE Frequently Asked Questions (FAQs)

• What is the maximum clock frequency that can be used with the TMS320C50PGE?
  The maximum clock frequency for the TMS320C50PGE is 50 MHz, but it can be overclocked to 60 MHz with careful consideration of power supply and thermal management.
• How do I implement a watchdog timer on the TMS320C50PGE?
  The TMS320C50PGE has a built-in watchdog timer that can be enabled and configured using the WDTR (Watchdog Timer Register) and WDTC (Watchdog Timer Counter) registers. The watchdog timer can be used to reset the device in case of a software fault or hang.
• Can I use the TMS320C50PGE with an external memory interface?
  Yes, the TMS320C50PGE has an external memory interface that allows it to access external memory devices such as SRAM, EPROM, or flash memory. The external memory interface is controlled by the External Memory Interface (EMIF) module.
• How do I handle interrupts on the TMS320C50PGE?
  The TMS320C50PGE has a vectored interrupt controller that allows it to handle up to 16 interrupt sources. Interrupts are prioritized and can be enabled or disabled using the Interrupt Enable (IE) and Interrupt Flag (IF) registers.
• What is the power consumption of the TMS320C50PGE?
  The power consumption of the TMS320C50PGE depends on the clock frequency, voltage, and operating mode. Typical power consumption is around 250 mW at 50 MHz and 3.3V, but can be reduced to around 10 mW in idle mode.