The maximum input voltage that can be applied to the TPS61016DGSR is 12V, but it's recommended to keep it below 10V for optimal performance and to prevent damage to the device.
To ensure the stability of the output voltage, it's essential to use a suitable output capacitor with a low equivalent series resistance (ESR) and a sufficient capacitance value. A minimum capacitance value of 10uF is recommended, and the capacitor should be placed as close to the output pin as possible.
The EN (enable) pin is used to turn the device on or off. When the EN pin is pulled high (above 1.4V), the device is enabled, and when it's pulled low (below 0.4V), the device is disabled. This pin can be used to implement power-saving modes or to turn the device on and off as needed.
The output voltage of the TPS61016DGSR can be calculated using the following formula: Vout = (R1 / R2) * (Vin - Vd), where R1 and R2 are the resistors connected to the FB pin, Vin is the input voltage, and Vd is the voltage drop across the internal diode (approximately 0.6V).
The maximum output current that the TPS61016DGSR can deliver is 1.5A. However, the actual output current may be limited by the input voltage, output voltage, and the internal resistance of the device.
TPS61016DGSR datasheet
by Texas Instruments
