022699 Search Results

SI-MAG3SM

Contextual Info: GM-FA-10J Gate Monitoring Safety Module 24V ac/dc operation, 1- or 2-Channel Input Original Instructions • Monitors one or two safety switches for a contact failure or wiring fault • Two output switching channels for connection to control-reliable power interrupt circuits

force piezo signal conditioning circuit for 4-20

Abstract: vacuum tube applications data book 41a Hall Effect Magnetic Sensors germanium
Contextual Info: PRESSURE CONVERSION TABLE Atmos Bars Dynes/cm2 In of Hg 0° C In of H20 (4° C) K grams/ meter2 Lb/in2 psi Lb/ft2 mm of Hg torr Microns Pascals 1 9.86923 x 10-1 9.86923 x 10-7 3.34207 x 10-2 2.458 x 10-3 9.678 x 10-5 0.068046 4.7254 x 10-4 1.316 x 10-3 1.316

Contextual Info: ES-FA-6G 1-Channel Emergency Stop Safety Module 24V ac/dc operation E-Stop Safety Module Features • Monitors one single-channel normally closed Emergency Stop switch circuit for a contact failure or wiring fault • Three output switching channels for connection to control-reliable power

siemens mccb

Abstract: SIEMENS circuit breakers mccb circuit breaker siemens mccb datasheet MCCB for welding application SWITCHGEAR IEEE STD 1015-1997 siemens electrical breaker CIRCUIT BREAKER siemens mccb circuit breaker DATASHEET
Contextual Info: Recognized as an American National Standard ANSI IEEE Std 1015-1997 IEEE Recommended Practice for Applying Low-Voltage Circuit Breakers Used in Industrial and Commercial Power Systems Sponsor Power Systems Protection Committee of the Industrial and Commercial Power Systems Department

SO-DIMM

Contextual Info: 4M x 32 Bit 3.3V UNBUFFERED EDO SODIMM Extended Data Out EDO DRAM SMALL OUTLINE DIMM 32400sEDM4G02TA 72 Pin 4Mx32 EDO SODIMM Unbuffered, 4k Refresh, 3.3V Pin Assignment General Description Pin# Front Side Pin# Back Side 1 GND 2 DQ0 3 DQ1 4 DQ2 5 DQ3 6 DQ4

RIA Contacts Type 329

Abstract: RPA-C2-10 RP-LS42F-75L RP-LS42F ISO12100-1 ISO13849-1 ISO13850 ISO12100-2 NFPA79
Contextual Info: Rope Pull Emergency Stop Switches RP-LS42F-75L. Series 42 mm Latching Switches with Rope Actuators Features •  Positive-opening safety contacts IEC 60947-5-1 , not dependent upon springs • Contacts latch open when rope is pulled; requires manual reset

Contextual Info: Model EM-T-7A Extension Module One- or two-channel control for use with a Primary Safety Device Features R R C • Extension Module provides additional safety outputs for a Primary Safety Device for example, an E-stop Safety Module or a 2-hand control module , if controlled

Contextual Info: STB Self-Checking Optical Touch Buttons † Self-Checking Ergonomic Actuating Devices Features • Diverse-redundant microcontroller-based photoelectric touch buttons • Continuous internal self-checking operation • Ergonomically designed to eliminate hand, wrist and arm stresses associated with

Contextual Info: SSM-FM-11A. Safe Speed Monitoring Modules Datasheet For over-speed, under-speed, and zero-speed detection • • • • • • • • • • • • • Dual-channel redundancy Monitors 2 sensors with PNP outputs Monitors rotation rpm or linear movement

EN894

Abstract: SC22-3 EN574 ISO13851 STBVR81 MBCC-512
Contextual Info: STB Self-Checking Optical Touch Buttons † Self-Checking Ergonomic Actuating Devices Features • Diverse-redundant microcontroller-based photoelectric touch buttons • Continuous internal self-checking operation • Ergonomically designed to eliminate hand, wrist and arm stresses associated with

AT-GM-13A

Abstract: EN292 AT-HM-13A tr121001 EN954-1 ISO13849-1 ISO13855 brake failure indicator two-hand S13-S22
Contextual Info: DUO-TOUCH SG Two-Hand Control Modules Models AT-GM-13A and AT-HM-13A, for use with two actuating devices Features • Diverse-redundant microcontrollers • Supplies power and monitors two Banner STB Self-Checking Optical Touch Buttons, or two mechanical push buttons

SI-MAG3SM

Abstract: circuit of GREEN HOUSE ROBOT EN954-1 transformer 2 mva IEC 60998 AC24V
Contextual Info: GM-FA-10J Gate Monitoring Safety Module 24V ac/dc operation, 1- or 2-Channel Input Original Instructions Features • Monitors one or two safety switches for a contact failure or wiring fault • Two output switching channels for connection to control-reliable power interrupt circuits

CRC16-polynomial circuit design

Abstract: DS1921 DS1921L-F5 DS9092 DS9093A DS9093RA DS9096P DS9101 time alarm DS1921
Contextual Info: DS1921 PRELIMINARY A DALLAS W SEM ICONDUCTOR SPECIAL FEATURES • Digital therm om eter m easures tem perature from -4 0 ° C to +70°C in 0.5°C increm ents • Tem perature conversion accuracy ± 1 °C from -2 0 °C to +70°C at tim e of calibration • Real Tim e C lock/calendar in BCD form at counts

Contextual Info: GM-FA-10J Gate Monitoring Safety Module 24V ac/dc operation, 1- or 2-Channel Input Original Instructions • Monitors one or two safety switches for a contact failure or wiring fault • Two output switching channels for connection to control-reliable power interrupt circuits

a2324

Contextual Info: E-Stop฀Safety฀Modules฀with฀Adjustable฀Delay Features •฀ ฀Selectable฀Auto-Reset฀or฀monitored฀Manual฀Reset. •฀฀Auto฀or฀manual฀power-up

Contextual Info: ES-FA-9AA and ES-FA-11AA E-Stop Safety Modules With 3 normally open safety outputs or 2 normally open safety outputs and 1 normally closed auxiliary output Original Instructions • Monitors emergency stop devices, such as palm buttons and rope/cable pulls, and positive-opening safety switches used for guard/gate interlocking

Contextual Info: SM-xA-5A Safety Mat Monitoring Modules SM-GA-5A 12-24V dc / 115V ac operation and SM-HA-5A (12-24V dc / 230V ac operation) • Monitors one 4-wire safety mat, or multiple mats in series • Selectable Automatic (Auto) Reset or Monitored Manual Reset • Input monitoring circuit incorporates redundant microprocessors

Contextual Info: E-Stop฀Safety฀Modules฀with฀Adjustable฀Delay Features •฀ ฀Selectable฀Auto-Reset฀or฀monitored฀Manual฀Reset. •฀฀ Auto฀or฀manual฀power-up

125A6A

Abstract: 125A10B
Contextual Info: Replacement - Tube Guitar Output 1750 Series TUBE GUITAR AMPLIFIER - OUTPUT TRANSFORMERS Guitar Amp • • • • Designed for drop in replacement of original tube guitar ampliier output transformers. Physically, parts were designed to look similar to original factory units (where possible).

Chokes

Abstract: 125A13A 125A6A 125C1A 125P34A
Contextual Info: Replacement - Tube Guitar Output 1750 Series TUBE GUITAR AMPLIFIER - OUTPUT TRANSFORMERS Guitar Amp • Designed for drop in replacement of original tube guitar amplifier output transformers. • Physically, parts were designed to look similar to original factory units (where possible).

EN418

Abstract: EN60204-1 EN954-1 IEC60947-5-1 UL991 EN292-1
Contextual Info: Emergency Stop Safety Modules Model ES-FA-9AA 24V ac/dc, 3 N/O Features • Monitors one dual-channel normally closed emergency stop switch circuit for a contact failure or wiring fault • The ES-FA-9AA has three output switching channels for connection to controlreliable power interrupt circuits

Project Report of fire alarm

Abstract: Westinghouse chiller ELEVATOR LOGIC CONTROL complete projects plc based automatic car parking system westinghouse switchgear NFPA-70B report on project of Elevator system using PLC light sensitive burglar alarm project westinghouse switchgear 1976 burglar alarm system abstract
Contextual Info: Recognized as an American National Standard ANSI IEEE Std 241-1990 (Revision of IEEE Std 241-1983) IEEE Recommended Practice for Electric Power Systems in Commercial Buildings Sponsor Power Systems Engineering Committee of the IEEE Industry Applications Society

resistive screen controlled robot

Abstract: inductive proximity sensor npn perimeter beam sensor circuit diagram B1117 10GH EN954-1 ossd output working principle scanner block diagram MMD-TA-12B B1116
Contextual Info: Muting Module Models MMD-TA-11B and MMD-TA-12B Instruction Manual Features • Compact, 67.5 mm DIN-mounted housing with plug-in terminal blocks. • For use with EZ-SCREEN Output Signal Switching Device OSSD outputs or MINI-SCREEN®, MICROSCREEN®, MACHINE-GUARD®, or other safety

EN574

Abstract: ISO13851 OTBVR81 EN954-1 ISO13849-1 ISO13855
Contextual Info: DUO-TOUCH – Two-Hand Control Modules Models AT-FM-2A, AT-AM-2A, and AT-BM-2A, for Use with Two Actuating Devices Features • Two redundant, forced-guided mechanically linked output contacts rated at 4 A • One auxiliary N.C. relay output rated at 0.5 A